Notes: QNAP IP address is 192.168.2.2 and that everything in this example uses 192.168.2.4 except the last two containers that are 192.168.2.5 (which could be moved to a new stack if needed) Not a working example, for demo version: '2. The way we use Docker, we always add at least one IP alias on the host, and map ports from the containers to ports listening on those ip aliases.
Example Notes: QNAP IP address is 192.168.2.2 and that everything in this example uses 192.168.2.4 except the last two containers that are 192.168.2.
When I have tried the example below only the first container came up for each new IP address When I have tried the example below only the first container came up for each new IP address. I’ve tried playing around with it but I am still new to docker and can’t figure it out or know if it even possible. Docker currently assumes that it manages the container network and nothing else is allowed to do so. Stop Docker from (blindly) assigning IP addresses when we specify the -bBRIDGE flag.
Docker ip address ymp how to#
I need to have these containers available to my LAN and would ideally like to have them all use a single IP address rather than NAT or give them each their own individual address (I know how to do that) but I’m not sure how. Make systemd available in the container this would boot the networking and get the IP address automatically for us. I have a production environment using Docker on my QNAP, I would like to set up a test environment where I can run experiment out without having to interrupt my production environment.